SAE J960_200102
Marine Control Cable Connection—Engine Clutch Lever
| * Secure PDF notice: |
The PDF document of the SAE standards that is downloaded will be locked and cannot be transferred to another computer; it is for a single workstation and a single user. The end user must have the FILE OPEN PLUG-IN security system installed. The document can be printed once. |
|---|---|
| Edition date: |
2001-02-14
In Force
|
| Available languages: | English |
| Summary: | The purpose of this SAE Recommended Practice is to provide guides toward standard conditions for operating marine hydraulic transmissions where push-pull cable control is applicable.
For control cable information see SAE J917.
a
Provide suitable detents at forward, neutral, and reverse positions. Approximately 22 N (5 lb) of cable force are required to move the engine clutch lever out of the detent positions.
b
Provide an engine clutch lever with a 6.35 mm (1/4 in) diameter hole at a radius to provide 70 mm (2-3/4 in) linear travel from forward to reverse, with neutral at the center.
The engine clutch lever (at 6.35 mm [1/4 in] diameter hole) to have 6.35 mm (1/4 in) maximum thickness.
Common cable terminals used are ball joints, clevises, and pivots.
c
Provide clear cable path to engine clutch lever.
d
Provide choice of cable paths from different angles. This can be done by providing a sector type of lever with a series of holes equidistant from the centerline of the shaft. It can also be done by having the engine clutch lever repositionable on the engine clutch control shaft.
e
Provide bracket support near the engine clutch control shaft. This can be a hub, bolt holes, bolt, or other means for use for attaching a cable anchor bracket.
A bolt pattern concentric with the engine clutch control shaft is desirable. |
| CTN: | |
|
Otras Relaciones |
Crossreference J917_201409 |










