ISO 14853:2016
Plastics — Determination of the ultimate anaerobic biodegradation of plastic materials in an aqueous system — Method by measurement of biogas production
| Fecha edición: |
2016-07-14
En Vigor
|
|---|---|
| Idiomas disponibles: | Inglés, Francés |
| Resumen: | ISO 14853:2016 specifies a method for the determination of the ultimate anaerobic biodegradability of plastics by anaerobic microorganisms. The conditions described in ISO 14853 do not necessarily correspond to the optimum conditions for the maximum degree of biodegradation to occur. The test calls for exposure of the test material to sludge for a period of up to 90 d, which is longer than the normal sludge retention time (25 to 30 d) in anaerobic digesters, although digesters at industrial sites can have much longer retention times. The method applies to the following materials: - natural and/or synthetic polymers, copolymers or mixtures thereof; - plastic materials which contain additives such as plasticizers, colorants or other compounds; - water-soluble polymers; - materials which, under the test conditions, do not inhibit the microorganisms present in the inoculum. Inhibitory effects can be determined using an inhibition control or by another appropriate method (see e.g. ISO 13641). If the test material is inhibitory to the inoculum, a lower test concentration, another inoculum or a pre-exposed inoculum can be used. L'ISO 14853:2016 spécifie une méthode pour la détermination de la biodégradabilité anaérobie ultime des plastiques par des micro-organismes anaérobies. Les conditions décrites dans l'ISO 14853:2016 ne correspondent pas nécessairement aux conditions optimales permettant d'obtenir le taux maximal de biodégradation. L'essai exige que le matériau d'essai soit exposé aux boues pendant une période allant jusqu'à 90 j, ce qui est plus long que le temps de rétention normal de la boue (25 j à 30 j) dans les digesteurs anaérobies, bien que les digesteurs sur les sites industriels puissent avoir des temps de rétention beaucoup plus longs. La présente méthode s'applique aux matériaux suivants: - polymères naturels et/ou synthétiques, copolymères ou mélanges de ceux-ci; - matériaux plastiques contenant des additifs, tels que plastifiants, colorants ou autres composés; - polymères hydrosolubles; - matériaux qui, dans les conditions d'essai, n'ont pas d'effet inhibiteur sur les micro-organismes présents dans l'inoculum. Les effets inhibiteurs peuvent être déterminés en utilisant une substance de contrôle de l'effet inhibiteur ou par toute autre méthode appropriée (voir, par exemple, l'ISO 13641). Si le matériau d'essai a un effet inhibiteur vis-à-vis de l'inoculum, il est possible d'utiliser une plus faible concentration, un autre inoculum ou un inoculum pré-exposé. |
| ICS: | 83.080.01 - Plásticos en general |
| CTN: | ISO/TC 61/SC 14 - 6578018 |
|
Anulaciones Normas |
Anula a ISO 14853:2005/Cor 1:2009 Anula a ISO 14853:2005 |
|
Equivalencia Internacional |
Idéntica UNE-EN ISO 14853:2018 |










