DIN EN 17176-5:2019-07
Plastics piping systems for water supply and for buried and above ground drainage, sewerage and irrigation under pressure - Oriented unplasticized poly(vinyl chloride) (PVC-O) - Part 5: Fitness for purpose of the system; German version EN 17176-5:2019 / Note: This standard is part of the DVGW body of rules.
| Edition date: |
2019-07-01
In Force
|
|---|---|
| Available languages: | English, German |
| Summary: | This document specifies the characteristics for the fitness for purpose of oriented unplasticized poly(vinyl chloride) (PVC-O) piping systems intended for water supply and for buried and above-ground drainage, sewerage, irrigation and conveyance of treated waste water under pressure. It also specifies the test parameters for the test methods referred to in this document. In conjunction with DIN EN 17176-1, DIN EN 17176-2 and DIN CEN/TS 17176-3, it is applicable to joints and assemblies with componenets of PVC-O, other plastics and non-plastics materials intended to be used for the following: a) water mains and service lines; b) conveyance of water above ground for both outside and inside buildings; c) drainage, sewerage and conveyance of treated waste water under pressure; d) irrigation under pressure. This document is applicable to piping systems intended for the supply of water with a maximum allowable operating pressure (PFA) up to and including 25 bar. The piping system according to this document is intended for the conveyance of cold water up to and including 45 °C and especially in those applications where special performance requirements are needed, such as impact loads and pressure fluctuations. |
| Keywords: | Component combination|Density|Drainage|Fitness for purpose|Irrigation|Materials|Mouldings (shaped section)|Oriented unplasticized polyvinyl chloride|Pipe couplings|Pipelines|Piping system|Plastic pipelines|Plastic pipes|Plastics|Polyvinyl chloride|Pressure pipes|Properties|PVC-O|PVC-pipes|Sewage|Sewage pipelines|Sewers|Underground|Unplasticized polyvinyl chloride|Water pipes|Water practice|Water supply |
| ICS: | 23.040.45-Plastics fittings, 23.040.20-Plastics pipes |
| CTN: | |
|
International Equivalence |
Identic EN 17176-5:2019 |
|
Reemplazo Normas |
Reemplaza a DIN EN 17176-5:2017-11 |










