ASTM D3359 - 23
Standard Test Methods for Rating Adhesion by Tape Test
| Aviso: | Las normas ASTM en lectura se visualizan a través del área decliente. Los archivos no se pueden descargar |
|---|---|
| Fecha edición: |
2023-02-01
En Vigor
|
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | adhesion; crosscut adhesion test method; tape; tape adhesion test method; X-cut adhesion test method; |
| Scope: | 1.1 These test methods cover procedures for assessing the adhesion of relatively ductile coating films to metallic substrates by applying and removing pressure-sensitive tape over cuts made in the film. 1.2 Test Method A is primarily intended to rate the adhesion of coatings and coating systems greater than 125 μm (5 mils) in total thickness, while Test Method B is primarily intended to rate the adhesion of coatings and coating systems less than 125 μm (5 mils) in total thickness. Test Method B is not considered suitable for films thicker than 125 μm (5 mils) unless wider spaced cuts are employed and there is an explicit agreement between the purchaser and seller. If the thickness of the coating or coating system has not been predetermined, employ the use of a standard such as Practice D7091 or other appropriate standard agreed upon by interested parties prior to proceeding. 1.3 These test methods are used to evaluate whether the adhesion of a coating to a substrate is adequate for the user’s application. They do not distinguish between higher levels of adhesion for which more sophisticated methods of measurement are required. 1.4 This test method is similar in content (but not technically equivalent) to ISO 2409. 1.5 In multicoat systems adhesion failure may occur between coats so that the adhesion of the coating system to the substrate is not determined. 1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 83.180 - Adhesivos |
| CTN: | D01.23 - D01.23 |
|
Otras Relaciones |
Es referenciada por F0977-22E01 Es referenciada por D6677-18R22 Es referenciada por D5367-16R21 Es referenciada por F1169-19 Es referenciada por D5065-17R21 Es referenciada por D5163-16R21 Es referenciada por F1043-18R22 Es referenciada por F0146-12R19E01 Es referenciada por D7254-21 Es referenciada por D5064-16AR21 Es referenciada por F1178-11R22 Es referenciada por F2933-21A Es referenciada por F1427-21E01 Es referenciada por B0449-93R22 Es referenciada por F2408-16R23 Es referenciada por F2589-16R21 Es referenciada por F3182-23 Es referenciada por F2285-22 Es referenciada por F1917-23 Es referenciada por F2388-21 |










