ASTM D1004 - 21
Standard Test Method for Tear Resistance (Graves Tear) of Plastic Film and Sheeting
| Aviso: | Las normas ASTM en lectura se visualizan a través del área decliente. Los archivos no se pueden descargar |
|---|---|
| Fecha edición: |
2021-01-15
En Vigor
|
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | Graves; plastic film; tear; tear initiation; thin sheeting; |
| Scope: | 1.1 This test method2 covers the determination of the tear resistance of flexible plastic film and sheeting at very low rates of loading, 51 mm (2 in.)/min. and is designed to measure the force to initiate tearing. The specimen geometry of this test method produces a stress concentration in a small area of the specimen. The maximum stress, usually found near the onset of tearing, is recorded as the tear resistance in newtons (or pounds-force). The method is not applicable for film or sheeting material where brittle failures occur during testing or where maximum extension is greater than 101.6 mm (4 in.). 1.1.1 Although resistance to tear can be expressed in newtons per microns, (pounds-force per mil) of specimen thickness, this is only advisable where correlation for the particular material being tested has been established. In most cases, comparison between films of dissimilar thickness is not valid. Note 1: Film has been arbitrarily defined as sheeting having nominal thickness not greater than 0.25 mm (0.010 in.). 1.2 Constant-Rate-of-Grip Separation Test—This test method employs a constant rate of separation of the grips holding the test specimen. 1.2.1 Specimen extension shall be measured in this test method by grip separation. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 2: There is no known ISO equivalent to this standard. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 83.140.10 - Películas y hojas |
| CTN: | D20.19 - D20.19 |
|
Anulaciones Normas |
Anula a D1004-13 |
|
Otras Relaciones |
Es referenciada por D2103 - 23a Es referenciada por D4434_D4434M-21 Es referenciada por D7008-08R22 Es referenciada por D5747_D5747M-21 Es referenciada por D7613-17R23 Es referenciada por D7176-22 Es referenciada por D4551-22 Es referenciada por F0942-18R23E01 Es referenciada por F0790-23 Es referenciada por D1593-22 Es referenciada por D1922-23 Es referenciada por D7106/D7106M - 25 Es referenciada por D4068-17R22 Es referenciada por F0561-19 Es referenciada por D3105 - 17(2024) Es referenciada por D8065/D8065M - 16(2023) Es referenciada por D6434 - 25 Es referenciada por D5047 - 17(2023) Es referenciada por F1742 - 03(2024) |










