ASTM C1472 - 16(2022)
Standard Guide for Calculating Movement and Other Effects When Establishing Sealant Joint Width
| Aviso: | Las normas ASTM en lectura se visualizan a través del área decliente. Los archivos no se pueden descargar |
|---|---|
| Fecha edición: |
2022-06-01
En Vigor
|
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | bridge joint; butt joint; construction tolerance; expansion joint; fillet joint; moisture movement; performance factor; sealant; sealant backing; sealant joint design; thermal movement; |
| Scope: | 1.1 This guide provides information on performance factors such as movement, construction tolerances, and other effects that should be accounted for to properly establish sealant joint size. It also provides procedures to assist in calculating and determining the required width of a sealant joint enabling it to respond properly to those movements and effects. Information in this guide is primarily applicable to single- and multi-component, cold-applied joint sealants and secondarily to precured sealant extrusions when used with properly prepared joint openings and substrate surfaces. 1.2 Although primarily directed towards the understanding and design of sealant joints for walls for buildings and other areas, the information contained herein is also applicable to sealant joints that occur in horizontal slabs and paving systems as well as various sloped building surfaces. 1.3 This guide does not describe the selection and properties of joint sealants (1)2, nor their use and installation, which is described by Guide C1193. 1.4 For protective glazing systems that are designed to resist blast and other effects refer to Guide C1564 in combination with this guide. 1.5 This guide is not applicable to the design of joints sealed with aerosol foam sealants. 1.6 For structural sealant glazing systems refer to Guide C1401 in combination with this guide. 1.7 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. SI units in this guide are in conformance with IEEE/ASTM SI 10-1997. 1.8 The Committee having jurisdiction for this guide is not aware of any comparable standards published by other organizations. 1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 91.100.50 - Aglomerantes. Materiales de estanquidad |
| CTN: | C24.10 - C24.10 |
|
Anulaciones Normas |
Anula a C1472-16E01 |
|
Otras Relaciones |
Es referenciada por C1193 - 25 Es referenciada por C0981-20 Es referenciada por C1535-05R23 Es referenciada por C1564 - 20(2024) Es referenciada por C1481 - 12(2024) Es referenciada por C898/C898M - 25 Es referenciada por C1397 - 25 Es referenciada por C1935 - 24 Es referenciada por C1401 - 23 |
Normas citadas
Libros relacionados
Normas relacionadas
Colecciones temáticas relacionadas
