ASTM A999/A999M - 98
Standard Specification for General Requirements for Alloy and Stainless Steel Pipe
| Warning: | ASTM standards for reading are viewed through the client area. Thefilescannot be downloaded. | ||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Edition date: |
2001-03-10
Cancelled
|
||||||||||||||||||||||||||||||||||
| Cancellation date: | 2001-03-10 | ||||||||||||||||||||||||||||||||||
| Available languages: | English | ||||||||||||||||||||||||||||||||||
| Summary: | |||||||||||||||||||||||||||||||||||
| Keywords: | alloy steel pipe; austenitic stainless steel; duplex stainless steel; ferritic/austenitic stainless steel; seamless steel pipe; stainless steel pipe; steel pipe; welded steel pipe | ||||||||||||||||||||||||||||||||||
| Scope: | 1.1 This specification covers a group of general requirements that, unless otherwise specified in an individual specification, shall apply to the ASTM product specifications noted below. 1.2 In the case of conflict between a requirement of a product specification and a requirement of this specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this specification and a more stringent requirement of the purchase order, the purchase order shall prevail.
1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. With the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation (SI) of the product specification is specified in the order. Note 1--The dimensionless designator NPS (nominal pipe size) is used in this standard for such traditional terms as "nominal diameter," "size,"" nominal bore," and "nominal size". 1.4 The following precautionary statement pertains only to the test method portion, Section 21, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||
| ICS: | 23.040.10-Iron and steel pipes | ||||||||||||||||||||||||||||||||||
| CTN: | A01.10 - A01.10 | ||||||||||||||||||||||||||||||||||
|
Otras Relaciones |
Es referenciada por F2283-12R18 Es referenciada por A0451_A0451M-20 Es referenciada por A0608_A0608M-20 Es referenciada por A0872_A0872M-21 Es referenciada por A1053_A1053M-12R22 Es referenciada por C0852_C0852M-17R22 Es referenciada por A0376_A0376M-22 |










