Estamos mejorando nuestra Tienda, Portal de clientes y Aenormas para ofrecerte una mejor experiencia.
Si detectas cualquier incidencia o necesitas ayuda durante el proceso de compra, puedes contactarnos a través del chat o escribirnos a normas@aenor.com.
Nuestro equipo estará encantado de ayudarte.
ASTM E1216 - 21
Standard Practice for Sampling for Particulate Contamination by Tape Lift
| Fecha edición: |
2021-09-01
En Vigor
|
||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Idiomas disponibles: | Inglés | ||||||||||||||
| Resumen: | |||||||||||||||
| Keywords: | particulate contamination; pressure-sensitive tape; sampling; | ||||||||||||||
| Scope: | 1.1 This practice covers procedures for sampling surfaces to determine the presence of particulate contamination, 5 μm and larger. The practice consists of the application of a pressure-sensitive tape to the surface followed by the removal of particulate contamination with the removal of the tape. The tape with the adhering particles is then mounted on counting slides. Counting and measuring of particles is done by standard techniques. 1.2 This practice describes the materials and equipment required to perform sampling of surfaces for particle counting and sizing. 1.3 The criteria for acceptance or rejection of a part for conformance to surface cleanliness level requirements shall be determined by the user and are not included in this practice. 1.4 This practice is for use on surfaces that are not damaged by the application of adhesive tape. The use of this practice on any surface of any material not previously tested, or for which the susceptibility to damage is unknown, is not recommended. In general, metals, metal plating, and oxide coatings will not be damaged. Application to painted, vapor deposited, and optical coatings should be evaluated before implementing this test. 1.5 This practice provides three methods to evaluate tape lift tests, as follows:
1.6 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||
| ICS: | 49.040 - Recubrimientos y procesos relacionados para la industria aeroespacial, 49.140 - Sistemas espaciales y puesta en servicio | ||||||||||||||
| CTN: | E21.05 - E21.05 | ||||||||||||||
|
Anulaciones Normas |
Anula a E1216-11R16 |
||||||||||||||
|
Otras Relaciones |
Es referenciada por E1548 - 23 Es referenciada por E2312-11R19 Es referenciada por E2352-19 Es referenciada por E2088-06R21 Es referenciada por F0051_F0051M-20 Es referenciada por D7602-11R17 Es referenciada por D7659-21 Es referenciada por E2217-12R19 |
||||||||||||||










