Estamos mejorando nuestra Tienda, Portal de clientes y Aenormas para ofrecerte una mejor experiencia.
Si detectas cualquier incidencia o necesitas ayuda durante el proceso de compra, puedes contactarnos a través del chat o escribirnos a normas@aenor.com.
Nuestro equipo estará encantado de ayudarte.
ASTM D696 - 16
Standard Test Method for Coefficient of Linear Thermal Expansion of Plastics Between −30°C and 30°C with a Vitreous Silica Dilatometer
| Fecha edición: |
2016-04-01
Anulada
|
|---|---|
| Fecha cancelación: | 2016-04-01 |
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | coefficient of expansion; linear expansion; plastics; thermal expansion; |
| Scope: | 1.1 This test method covers determination of the coefficient of linear thermal expansion for plastic materials having coefficients of expansion greater than 1 µm/(m.°C) by use of a vitreous silica dilatometer. At the test temperatures and under the stresses imposed, the plastic materials shall have a negligible creep or elastic strain rate or both, insofar as these properties would significantly affect the accuracy of the measurements. 1.1.1 Test Method E228 shall be used for temperatures other than −30°C to 30°C. 1.1.2 This test method shall not be used for measurements on materials having a very low coefficient of expansion (less than 1 µm/(m.°C). For materials having very low coefficient of expansion, interferometer or capacitance techniques are recommended. 1.1.3 Alternative technique commonly used for measuring this property is thermomechanical analysis as described in Test Method E831, which permits measurement of this property over a scanned temperature range. 1.2 The thermal expansion of a plastic is composed of a reversible component on which are superimposed changes in length due to changes in moisture content, curing, loss of plasticizer or solvents, release of stresses, phase changes and other factors. This test method is intended for determining the coefficient of linear thermal expansion under the exclusion of these factors as far as possible. In general, it will not be possible to exclude the effect of these factors completely. For this reason, the test method can be expected to give only an approximation to the true thermal expansion. 1.3 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this standard. |
| ICS: | 83.080.01 - Plásticos en general |
| CTN: | D20.30 - D20.30 |
|
Otras Relaciones |
Es referenciada por F1488 - 25 Es referenciada por D4216-22 Es referenciada por F3319-20 Es referenciada por D3841-21 Es referenciada por D0229-19E01 Es referenciada por F3459-21 Es referenciada por D6455-11R18 Es referenciada por F2021-17R22 Es referenciada por D0710-19 Es referenciada por D7745-19 Es referenciada por E0289-17 Es referenciada por D3678-19 Es referenciada por F1499-22 Es referenciada por F0942-18R23E01 Es referenciada por E0228-22 Es referenciada por F0790-23 Es referenciada por D3105-17R24 Es referenciada por D4762-23 Es referenciada por F2855-19R24 Es referenciada por D7793-24 |










