Estamos mejorando nuestra Tienda, Portal de clientes y Aenormas para ofrecerte una mejor experiencia.
Si detectas cualquier incidencia o necesitas ayuda durante el proceso de compra, puedes contactarnos a través del chat o escribirnos a normas@aenor.com.
Nuestro equipo estará encantado de ayudarte.
ASTM D6108 - 19
Standard Test Method for Compressive Properties of Plastic Lumber and Shapes
| Fecha edición: |
2019-05-01
Anulada
|
|---|---|
| Fecha cancelación: | 2019-05-01 |
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | compressive properties; compressive strength; modulus of elasticity; plastic lumber; plastic shapes; recycled plastic; secant modulus; stress at a given strain; |
| Scope: | 1.1 This test method covers the determination of the mechanical properties of plastic lumber and shapes, when the entire cross-section is loaded in compression at relatively low uniform rates of straining or loading. Test specimens in the “as-manufactured” form are employed. As such, this is a test method for evaluating the properties of plastic lumber or shapes as a product and not a material property test method. 1.2 Plastic lumber and plastic shapes are currently made predominantly with recycled plastics. However, this test method would also be applicable to similar manufactured plastic products made from virgin resins, or where the product is non-homogenous in the cross-section. 1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this test method. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 83.140.01 - Productos de elastómeros y plásticos en general |
| CTN: | D20.20 - D20.20 |
|
Anulaciones Normas |
Anula a D6108-18 |
|
Otras Relaciones |
Es referenciada por E2925-19A Es referenciada por E2954-15R22 Es referenciada por D7568-23 Es referenciada por D7258-23 Es referenciada por D6111-24 |










