Estamos mejorando nuestra Tienda, Portal de clientes y Aenormas para ofrecerte una mejor experiencia.
Si detectas cualquier incidencia o necesitas ayuda durante el proceso de compra, puedes contactarnos a través del chat o escribirnos a normas@aenor.com.
Nuestro equipo estará encantado de ayudarte.
ASTM D5514/D5514M - 24
Standard Test Methods for Large-Scale Hydrostatic Puncture Testing of Geosynthetics
| Fecha edición: |
2024-06-01
En Vigor
|
|---|---|
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | geosynthetics; hydrostatic pressure; large-scale puncture; performance testing; puncture resistance; |
| Scope: | 1.1 These test methods evaluate the stress/time properties of geosynthetics by using hydrostatic pressure to compress the geosynthetic over a subgrade. 1.2 These test methods allow the user to determine the relative failure mode or points of failure for geosynthetics, or both. 1.3 Procedures B and C incorporate site-specific soil or other material selected by the user as the test base of the testing apparatus. Procedures B and C are methods for geosynthetic design for a specific site. Note 1: Earlier versions of this test method incorporated a ‘Procedure A’ involving manufactured test pyramids or cones as the base of the testing apparatus. This procedure was withdrawn, but the designations B and C were retained to avoid confusion on historical specifications and technical data sheets. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific warning statement, see Section 6. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 59.080.70 - Geotextiles |
| CTN: | D35.10 - D35.10 |
|
Anulaciones Normas |
Anula a D5514_D5514M-18 |
|
Otras Relaciones |
Es referenciada por D6455-11R18 Es referenciada por D4439 - 25a Es referenciada por D6434 - 25 Es referenciada por D7106/D7106M - 25 |










