Estamos mejorando nuestra Tienda, Portal de clientes y Aenormas para ofrecerte una mejor experiencia.
Si detectas cualquier incidencia o necesitas ayuda durante el proceso de compra, puedes contactarnos a través del chat o escribirnos a normas@aenor.com.
Nuestro equipo estará encantado de ayudarte.
ASTM D2990 - 17
Standard Test Methods for Tensile, Compressive, and Flexural Creep and Creep-Rupture of Plastics
| Fecha edición: |
2017-03-01
Anulada
|
|---|---|
| Fecha cancelación: | 2017-03-01 |
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | creep; creep-rupture; plastics; |
| Scope: | 1.1 These test methods cover the determination of tensile and compressive creep and creep-rupture of plastics under specified environmental conditions (see 3.2). 1.2 In these test methods three-point loading, as described in Test Methods D790, is used for measurement of creep in flexure. However, four-point loading using the equipment and principles described in D6272 is also permitted as an option. 1.3 For measurements of creep-rupture, tension is the preferred stress mode because for some ductile plastics rupture does not occur in flexure or compression. 1.4 Test data obtained by these test methods are relevant and appropriate for use in engineering design. 1.5 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific warning statement is given in 6.8.2. Note 1: This standard and ISO 899 Parts 1 and 2 address the same subject matter, but differ in technical content (and results cannot be directly compared between the two test methods). ISO 899 Part 1 addresses tensile creep and creep to rupture and ISO 899 Part 2 addresses flexural creep. Compressive creep is not addressed in ISO 899. |
| ICS: | 83.080.01 - Plásticos en general |
| CTN: | D20.10 - D20.10 |
|
Otras Relaciones |
Es referenciada por F2902 - 24 Es referenciada por D7931_D7931M-21A Es referenciada por F2881_F2881M-21E01 Es referenciada por F3510-21 Es referenciada por F0561-19 Es referenciada por D5262-21 Es referenciada por D5819-22 Es referenciada por F2922 - 25a Es referenciada por D7361 - 07(2023) Es referenciada por F3430 - 25 Es referenciada por F2418 - 25 Es referenciada por F2764/F2764M - 24 Es referenciada por D6992 - 16(2023) Es referenciada por D4101 - 24 Es referenciada por F2150-19 Es referenciada por D7406-20 Es referenciada por D5592-94R18 Es referenciada por D0907-15R23 Es referenciada por F2599-22 Es referenciada por F2019-22 |










