Buscador de normas

Tonne Kilometer Per Hour Application

Snowmobile Drive Mechanisms

Minimum Operational Performance Specification for Remote On-Ground Ice Detection Systems

Steel, Maraging, Bars, Forgings, Mechanical Tubing, Flash-Welded Rings, and Stock for Forging and Flash-Welded Rings, 19Ni - 3.0Mo - 1.4Ti - 0.10Al (Alloy T250), Premium Aircraft Quality, Double Vacuum Melted, Annealed

Inspection Material, Penetrant

Plating, Zinc-Nickel Alloy (12 to 16% Ni)

Titanium Alloy, Sheet, Strip, and Plate, 6Al - 4V, Annealed

Guidelines for Characterization of Gas Turbine Engine Total-Pressure, Planar-Wave, and Total-Temperature Inlet-Flow Distortion

Automated Gaseous Nitriding Controlled by Nitriding Potential

Gaseous Nitriding of Steel Parts, Controlled by Ammonia Dissociation

Titanium Alloy Bars, Forgings, and Forging Stock, 7.0Al - 4.0Mo, Annealed

Steel, Corrosion- and Heat-Resistant, Bars, Wire, Forgings, and Forging Stock, 12Cr - 0.50Mo (410 plus Mo), Annealed

Approval and Control of Premium-Quality Titanium Alloys

Aircraft and Aircraft Engine Fuel Pump Low Lubricity Fluid Endurance Test

Wheel End Assembly and Axle Spindle Interface Dimensions - Truck and Bus

Titanium Alloy Bars, Forgings, and Forging Stock 3Al - 8V - 6Cr - 4Mo - 4Zr Solution Heat Treated

Aluminum Alloy Extrusions, 7.9Zn - 1.6Cu - 2.2Mg - 0.16Cr (7249-T76511), Solution Heat Treated, Stress-Relieved, Straightened, and Overaged

Peening Media Conditioned Stainless Steel Cut Wire Shot (AWS)

Peening Media for Ultrasonically Activated Shot Peening

Nickel Alloy, Corrosion- and Heat-Resistant, Wire, 74Ni - 15.5Cr - 8.0Fe, Cold Reduced, Spring Temper

Peening Media Conditioned Carbon Steel Cut Wire Shot, High Hardness (55 to 62 HRC) (AWCH)

Peening Media Conditioned Carbon Steel Cut Wire Shot, Regular Hardness (45 to 52 HRC) (AWCR)

HOSE ASSEMBLY, POLYTETRAFLUOROETHYLENE, CRES REINFORCED, 400 °F, 3000 PSI, LIGHTWEIGHT, BEAM SEAL, STRAIGHT TO 90°

Zinc Phosphate Treatment Paint Base