Saltar navegación principal
Estás en: Home>Normas>Buscador de normas>ASTM
ASTM A325M-05

ASTM A325M-05

Standard Specification for Structural Bolts, Steel, Heat Treated 830 MPa Minimum Tensile Strength [Metric]

2010-12-31 /Historical
Superseeded by:

1.1 This specification covers two types of quenched and tempered, steel, metric heavy hex structural bolts having a minimum tensile strength of 830 MPa (Note 1).

1.2 The bolts are intended for use in structural connections. These connections are comparable to those covered under the requirements of the Specification for Structural Joints using ASTM A 325 or A 490 bolts, approved by the Research Council on Structural Connections; endorsed by the American Institute of Steel Construction and by the Industrial Fastener Institute.

1.3 The bolts are furnished in sizes M12 to M136 inclusive. They are designated by type denoting chemical composition as follows:

1.3.1 Type 1—Medium-carbon, carbon boron, medium carbon alloy, or alloy boron steel.

1.3.2 Type 2—Withdrawn in 2003.

1.3.3 Type 3—Weathering Steel.

1.4 This specification is applicable to metric heavy hex, structural bolts only.

1.5 Terms used in this specification are defined in Specification F 1789.

1.6 The following safety hazards caveat pertains only to the test methods portion, Section 10, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Note 1—This specification is the metric companion to the inch pound Specification A 325.

alloy steel; bolts; carbon steel; metric; steel; structural; weathering steel
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Descuentos no acumulables

Añadir a la cesta