BS EN ISO 18563-2:2024
Non-destructive testing. Characterization and verification of ultrasonic phased array equipment. Array probes
| Fecha edición: |
2024-10-04
En Vigor
|
|---|---|
| Idiomas disponibles: | Inglés |
| Resumen: | This document specifies characterization tests to be performed at
the end of the fabrication of an array probe. It defines both
methodology and acceptance criteria. This document is applicable to
the following array probes used for ultrasonic non-destructive
testing [phased array technique or signal processing technique,
e.g. full-matrix capture (FMC) and total-focusing technique (TFM)]
in contact technique (with or without a wedge or delay line) or in
immersion technique, with centre frequencies in the range 0,5 MHz
to 10 MHz: a) array probes with elements in one direction: —
1-D-linear array (linear array); — 1-D-curved array; —
annular array; b) array probes with elements in two
directions: — 2-D-array (matrix array); — sectorial annular
array; — partial sectorial annular array. This document does not
give methods and acceptance criteria to characterize the
performance of an ultrasonic phased array instrument or the
performance of a complete system, which are given in ISO 18563–1
and in ISO 18563–3.
|
| ICS: | |
| CTN: | WEE/46/3 - WEE/46/3 |
|
Equivalencia Internacional |
Idéntica EN ISO 18563-2:2024 Idéntica ISO 18563-2:2024 |
|
Reemplazo Normas |
Reemplaza a BS EN ISO 18563-2:2017 |










