ASTM E1590 - 23
Standard Test Method for Fire Testing of Mattresses
| Aviso: | Las normas ASTM en lectura se visualizan a través del área decliente. Los archivos no se pueden descargar |
|---|---|
| Fecha edición: |
2023-02-01
En Vigor
|
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | calorimetry; carbon dioxide; carbon monoxide; fire; fire-test-response; heat release; ignition; mattress; oxygen consumption; smoke obscuration; toxic combustion gases ; |
| Scope: | 1.1 This is a fire-test-response standard. 1.2 This test method provides a means of determining the burning behavior of mattresses used in public occupancies by measuring specific fire test responses when the test specimen, a mattress or mattress with foundation, is subjected to a specified flaming ignition source under well ventilated conditions. 1.3 This is a test method for mattresses or mattresses with foundations. 1.4 Test data are obtained describing the burning behavior, following application of a specific ignition source, from ignition until all burning has ceased, a period of 1 h has elapsed, or flashover appears inevitable. 1.5 This test method does not provide information on the fire performance of mattresses under fire conditions other than those specified in this test method. In particular, this test method does not apply to smoldering ignition by cigarettes. See 5.12 for further information. 1.6 The rate of heat release of burning test specimen is measured by an oxygen consumption method. See 5.12.4 for further information. 1.7 Other measurements are the production of light-obscuring smoke and the concentrations of certain toxic gas species in the combustion gases. See 5.12.5 for further information. 1.8 The burning behavior is documented visually by photographic or video recordings. 1.9 Units—Use the SI system of units in referee decisions; see IEEE/ASTM SI-10. The units given in parentheses are for information only. 1.10 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products or assemblies under actual fire conditions. 1.11 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests. 1.12 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.13 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 13.220.40 - Comportamiento frente al fuego e inflamabilidad de materiales y productos, 97.140 - Mobiliario |
| CTN: | E05.21 - E05.21 |
|
Anulaciones Normas |
Anula a E1590-22 |
|
Otras Relaciones |
Es referenciada por E2280 - 25a Es referenciada por E2061 - 23 Es referenciada por F1550-22 Es referenciada por F1870-22 Es referenciada por E1995-21 Es referenciada por E3020-22 Es referenciada por E2574_E2574M-17R21 Es referenciada por E1822-21 Es referenciada por E2102 - 24 Es referenciada por F1085 - 19(2024) Es referenciada por E176 - 24a Es referenciada por E603 - 25 Es referenciada por E2067 - 24 |










