| Warning: | ASTM standards for reading are viewed through the client area. Thefilescannot be downloaded. |
|---|---|
| Edition date: |
2022-09-01
In Force
|
| Available languages: | English |
| Summary: | This specification covers reinforced concrete culvert, storm drain, and sewer pipe. The pipe manufactured with this specification shall be of five classes: Class I, Class II, Class III, Class IV, and Class V. The strength requirements for each class are specified. The reinforced concrete shall consists of: cementitious materials, mineral aggregates, and water. Cementitious materials are the following: cement, ground granulated blast-furnace slag, fly ash, and allowable combinations of cementitious materials. Other materials include: admixtures and blends, steel reinforcement, and synthetic fibers. Design tables and modified of special designs are given. Reinforcements are the following: circumferential reinforcement, longitudinal reinforcement, and joint reinforcement for rubber and non-rubber gasket joints. The physical properties shall conform to the required test for external load crushing strength. The following concrete tests shall be done: compression testing of cylinders, compression testing of cores, absorption test, and equipment test. |
| Keywords: | circular pipe; culvert; D-load; pipe; reinforced concrete; sewer pipe; storm drain; |
| Scope: | 1.1 This specification covers reinforced concrete pipe intended to be used for the conveyance of sewage, industrial wastes, and storm water, and for the construction of culverts. 1.2 This specification is the SI companion to Specification C76; therefore, no inch-pound equivalents are presented in this specification. Reinforced concrete pipe that conform to the requirements of C76 are acceptable under this Specification C76M unless prohibited by the Owner. Note 1: Note 2: Attention is called to the specification for reinforced concrete D-load culvert, storm drain, and sewer pipe (ASTM Designation C655M). 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 23.040.50-Pipes and fittings of other materials |
| CTN: | C13.02 - C13.02 |
|
Standards Cancellations |
Anula a C0076M-22 |
|
Otras Relaciones |
Es referenciada por C0443M-21 Es referenciada por C990/C990M - 25 Es referenciada por C1846/C1846M - 19(2024) Es referenciada por C76 - 25 |
UNE-EN IEC 60794-1-301:2024
Cables de fibra óptica. Parte 1-301: Especificación genérica. Procedimientos básicos de ensayo para cables ópticos. Métodos de ensayo de elementos de cable. Ensayo de flexión, método G1.
| Edition date: |
2024-02-14
In Force
|
|---|---|
| Available languages: | English, Spanish |
| ICS: | 33.180.10-Fibres and cables |
| CTN: | CTN 212/SC 86 - Fibras ópticas |
|
International Equivalence |
Identic EN IEC 60794-1-301:2023 Identic IEC 60794-1-301:2023 |
|
Otras Versiones Vigentes |
Conjunta UNE-EN IEC 60794-1-23:2022 |










