ASTM E930 - 18
Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size)
| Warning: | ASTM standards for reading are viewed through the client area. Thefilescannot be downloaded. |
|---|---|
| Edition date: |
2018-12-01
In Force
|
| Available languages: | English |
| Summary: | |
| Keywords: | ALA grain; caliper diameter; comparison procedure; ellipse measurement; grain size; largest grain; measuring procedure; metallography; microstructure; outlier grain; point-count procedure; |
| Scope: | 1.1 These test methods describe simple manual procedures for measuring the size of the largest grain cross-section observed on a metallographically prepared plane section. 1.2 These test methods shall only be valid for microstructures containing outlier coarse grains, where their population is too sparse for grain size determination by Test Methods E112. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 19.120-Particle size analysis. Sieving |
| CTN: | E04.08 - E04.08 |
|
Standards Cancellations |
Anula a E0930-99R15 |
|
Otras Relaciones |
Es referenciada por F0799-19 Es referenciada por E1382-97R23 Es referenciada por E1181-02R23 Es referenciada por E112 - 25 |










