ASTM E517 - 24
Standard Test Method for Plastic Strain Ratio r for Sheet Metal
| Warning: | ASTM standards for reading are viewed through the client area. Thefilescannot be downloaded. |
|---|---|
| Edition date: |
2024-03-01
In Force
|
| Available languages: | English |
| Summary: | |
| Keywords: | drawability; earing tendency; plastic strain ratio; |
| Scope: | 1.1 This test method covers special tension testing for the measurement of the plastic strain ratio, r, of sheet metal intended for deep-drawing applications. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 77.040.10-Mechanical testing of metals |
| CTN: | E28.02 - E28.02 |
|
Standards Cancellations |
Anula a E0517-19 |
|
Otras Relaciones |
Es referenciada por A463/A463M - 25 Es referenciada por A0653_A0653M-23 Es referenciada por A0792_A0792M-23 Es referenciada por A0875_A0875M-23 Es referenciada por A1083_A1083M-23 Es referenciada por E2218-23 Es referenciada por A1008/A1008M - 24 Es referenciada por A1046/A1046M - 24 |










