Normas SAE
Filtrar:
SAE
SAE
SAE
SAE AMS5509A
In Force
1981-01-01
Alloy, Sheet, Strip, and Plate, 15cr 45ni 4w 4mo 3ti 1al Consumable
Electrode Vacuum Melted
SAE
SAE AMS5628F
In Force
2006-10-01
Steel, Corrosion-Resistant, Bars, Wire, Forgings, and Tubing 16Cr -
2.5Ni (SAE 51431)
SAE
SAE
SAE
SAE AMS5834A
In Force
1991-10-01
ALLOY WIRE, CORROSION AND HEAT RESISTANT 20Cr - 15Ni - 40Co - 7.0Mo -
16Fe Solution Heat Treated, Cold Drawn, and Aged
SAE
SAE AS85049/124A_A2
In Force
2003-06-20
Connector Accessories, Electrical, Strain Relief, Straight
Self-Locking, Category 4C (For MIL-DTL-38999 Series III and IV Connectors
SAE
SAE AMS5355E
In Force
1994-11-01
STEEL, CORROSION RESISTANT, INVESTMENT CASTINGS 16Cr - 4.1Ni - 0.28Cb -
3.2Cu Homogenization and Solution Heat Treated or Homogenization,
Solution, and Precipitation Heat Treated
SAE
SAE J588_199106
In Force
1991-06-30
TURN SIGNAL LAMPS FOR USE ON MOTOR VEHICLES LESS THAN 2032 MM IN OVERALL WIDTH
SAE
SAE AS153B
In Force
1998-03-01
HOSE ASSEMBLY, NONMETALLIC, 3000 psi, TFE, FLARED, STRAIGHT TO STRAIGHT, LIGHTWEIGHT
SAE
SAE AS8090A
In Force
2016-02-01
Mobility, Towed Aerospace Ground Equipment, General Requirements For
SAE
SAE
SAE AS85049/88A_A1
In Force
2000-06-01
Connector Accessories, Electrical, Backshell, Straight, Self-Locking,
Shield Band Termination (RFI/EMI), Shrink Boot Accommodation, Category
3B (For MIL-DTL-38999 Series III and IV Connectors)
SAE
SAE AIR4023
In Force
1993-04-01
AIRCRAFT TURBINE FUEL CONTAMINATION HISTORY AND ENDURANCE TEST REQUIREMENTS
SAE
SAE AS22759_A1
In Force
2001-07-01
Wire, Electrical, Fluoropolymer-Insulated, Copper or Copper Alloy
SAE
SAE
SAE
SAE AS85049/115B_A2
In Force
2002-05-21
Connector Accessories, Electrical Backshell, Straight, Self Locking and
Non-Self Locking, Pre-Attached Shield Termination (RFI/EMI), Boot
Accommodation, Category 3B (For MIL-DTL-38999 Series III and IV Connectors)
SAE
SAE AMS6450G
In Force
2002-05-01
Steel, Spring Wire and Springs 0.95Cr - 0.22V (0.48 - 0.53C) (SAE 6150)
Annealed and Cold Drawn
SAE
SAE AS85731_A1
In Force
2004-06-24
Fastener, Positive Locking, Electronic Equipment, General Specification For
SAE
SAE
SAE
SAE
SAE AMS4860C
In Force
1992-04-01
MANGANESE BRONZE CASTINGS, SAND AND CENTRIFUGAL 58Cu - 39Zn - 1.2Fe -
1.0Al - 0.80Mn (CDA 86500) As Cast
SAE
SAE AMS5778C
In Force
1991-10-01
ALLOY WELDING WIRE, CORROSION AND HEAT RESISTANT 72Ni - 15.5Cr - 1.0(Cb
+ Ta) - 2.4Ti - 0.70Al - 7.0Fe
SAE
SAE AS4290
In Force
2001-10-01
Validation Test Plan for AS4074 Linear Token Passing Multiplex Data Bus
SAE
SAE
SAE AS24463C
In Force
2014-06-01
BEARING, ROLLER, NEEDLE-SINGLE ROW, HEAVY DUTY, SELF-ALIGNING, TYPE III,
ANTIFRICTION, INCH
SAE
SAE AMS5865B
In Force
1992-04-01
NICKEL SHEET AND STRIP, CORROSION AND HEAT RESISTANT Thoria Dispersion
Strengthened 2.2ThO2
SAE
SAE AS1715C
In Force
2001-12-01
WASHER, COUPLING, FLEXIBLE, VARIABLE CAVITY, THREADED, FERRULE TYPE TUBE ENDS
SAE
SAE
SAE
SAE
SAE AS7928/4_A1
In Force
1999-04-01
Terminals, Lug and Splices, Conductor, Crimp Style, Copper Terminal,
Lug, Insulated, Ring Tongue, Bell-Mouthered, Type II, Class 1 (for
105°C Total Conductor Temperature)
SAE
SAE AMS4132J
In Force
2026-03-12
Aluminum Alloy, Die and Hand Forgings, and Rolled Rings, 2.3Cu - 1.6Mg -
1.1Fe - 1.0Ni - 0.18Si - 0.07Ti (2618-T61), Solution and Precipitation
Heat Treated
SAE
SAE AMS3915B
In Force
2026-05-28
Advanced Composites Prepreg - Nominal 250 °F (121 °C) Cure - Glass Fiber
and Epoxy Resin, 7781 Weave Fabric
SAE
SAE J2040_200203
In Force
2002-03-19
Tail Lamps (Rear Position Lamps) for Use on Vehicles 2032 mm or More in
Overall Width
SAE
SAE J845_199203
In Force
1992-03-16
360 DEGREE WARNING DEVICES FOR AUTHORIZED EMERGENCY, MAINTENANCE, AND
SERVICE VEHICLES
SAE
